JC POWER supplies hardware plating lines from decorative chrome to zinc and iron. The electroplating platform runs 500–8000A at DC 0–12V with ≤1% regulation; chrome work moves to the low-ripple series at 1000–50000A and ≤3% ripple. Cooling follows duty, from forced air to water.
JC POWER supplies hardware plating lines from decorative chrome to zinc and iron. The electroplating platform runs 500–8000A at DC 0–12V with ≤1% regulation; chrome work moves to the low-ripple series at 1000–50000A and ≤3% ripple. Cooling follows duty, from forced air to water.
Bath chemistry sets the waveform. Decorative chrome reacts to ripple before it reacts to nameplate current, so ≤3% becomes the leading figure. Zinc and iron baths accept looser ripple; the iron plating power supply states ≤5% with three output states.
General hardware plating uses the electroplating power supply at 500–8000A with air or water cooling. Chrome work uses the low-ripple chrome plating power supply. Lines needing timed reversal use the automatic reverse power supply at 1000–50000A.
Set the ripple ceiling in the technical condition, then record ripple and ≤1% regulation at acceptance. Cooling depends on duty: forced air below 10kA, water cooling above 20kA for the chrome series. Both standard and custom models carry a one-year warranty and a 15–20 day lead time.
· Set current by plated area × current density, with 15–20% headroom · Ripple ≤3% for decorative and hard chrome; ≤1% is workable for routine nickel and zinc plating · Check periodic reverse and pulse parameters for complex parts · Use water cooling for continuous high-current tanks and air cooling for small intermittent tanks
Sales 0757-81270279 · After-sales 17765622069
Email jiechuangkeji@163.com
Bath chemistry sets the waveform. Decorative chrome reacts to ripple before it reacts to nameplate current, so ≤3% becomes the leading figure. Zinc and iron baths accept looser ripple; the iron plating power supply states ≤5% with three output states.
General hardware plating uses the electroplating power supply at 500–8000A with air or water cooling. Chrome work uses the low-ripple chrome plating power supply. Lines needing timed reversal use the automatic reverse power supply at 1000–50000A.
Set the ripple ceiling in the technical condition, then record ripple and ≤1% regulation at acceptance. Cooling depends on duty: forced air below 10kA, water cooling above 20kA for the chrome series. Both standard and custom models carry a one-year warranty and a 15–20 day lead time.
View Electroplating power supply series parameters →




Answers follow a condition–parameter–recommended model format so you can match them to your own line.
Bath chemistry sets the waveform. Decorative chrome reacts to ripple before it reacts to nameplate current, so ≤3% becomes the leading figure. Zinc and iron baths accept looser ripple; the iron plating power supply states ≤5% with three output states.
General hardware plating uses the electroplating power supply at 500–8000A with air or water cooling. Chrome work uses the low-ripple chrome plating power supply. Lines needing timed reversal use the automatic reverse power supply at 1000–50000A.
Set the ripple ceiling in the technical condition, then record ripple and ≤1% regulation at acceptance. Cooling depends on duty: forced air below 10kA, water cooling above 20kA for the chrome series. Both standard and custom models carry a one-year warranty and a 15–20 day lead time.
Scan to add a JC POWER engineer
Weekdays 8:30–18:00 · 0757-81270279