JC POWER covers profile finishing from ordinary anodizing to hard coat and electrolytic color. The anodizing platform runs 0–1000kVA with 1%–3% ripple and ≤1% regulation; hard coat adds a 500:1 duty ratio and a 1–32min soft start, while coloring an AC stage.
JC POWER covers profile finishing from ordinary anodizing to hard coat and electrolytic color. The anodizing platform runs 0–1000kVA with 1%–3% ripple and ≤1% regulation; hard coat adds a 500:1 duty ratio and a 1–32min soft start, while coloring an AC stage.
Ordinary coating needs steady DC and ripple between 1% and 3%. Hard coat needs a long ramp and an off interval to control heat, expressed as a 500:1 on/off ratio and 1–32min soft start. Coloring adds an AC stage after oxide formation.
Profile lines use the anodizing power supply at 0–1000kVA. Hard coat uses the hard anodizing power supply with ±1% output accuracy and four modes. Coloring uses the AC/DC coloring power supply with DC 0–25V and AC 0–30V stages.
Check soft start, on/off ratio, and ±1% accuracy against the coating recipe at acceptance. Current density is sized from tank area and is not fixed here. Allow 15–20 days for delivery on standard and custom models; each carries a one-year warranty.
· Set current by maximum workpiece area × current density, with 15–20% headroom · Ripple ≤3% for conventional anodizing and ≤1% recommended for hard anodizing · For hard anodizing, check multi-stage curves, soft start and a 500:1 on/off ratio · Prefer water cooling for continuous tanks; use an AC/DC coloring supply for the coloring stage
Sales 0757-81270279 · After-sales 17765622069
Email jiechuangkeji@163.com
Ordinary coating needs steady DC and ripple between 1% and 3%. Hard coat needs a long ramp and an off interval to control heat, expressed as a 500:1 on/off ratio and 1–32min soft start. Coloring adds an AC stage after oxide formation.
Profile lines use the anodizing power supply at 0–1000kVA. Hard coat uses the hard anodizing power supply with ±1% output accuracy and four modes. Coloring uses the AC/DC coloring power supply with DC 0–25V and AC 0–30V stages.
Check soft start, on/off ratio, and ±1% accuracy against the coating recipe at acceptance. Current density is sized from tank area and is not fixed here. Allow 15–20 days for delivery on standard and custom models; each carries a one-year warranty.
View model specifications →




Answers follow a condition–parameter–recommended model format so you can match them to your own line.
Ordinary coating needs steady DC and ripple between 1% and 3%. Hard coat needs a long ramp and an off interval to control heat, expressed as a 500:1 on/off ratio and 1–32min soft start. Coloring adds an AC stage after oxide formation.
Profile lines use the anodizing power supply at 0–1000kVA. Hard coat uses the hard anodizing power supply with ±1% output accuracy and four modes. Coloring uses the AC/DC coloring power supply with DC 0–25V and AC 0–30V stages.
Check soft start, on/off ratio, and ±1% accuracy against the coating recipe at acceptance. Current density is sized from tank area and is not fixed here. Allow 15–20 days for delivery on standard and custom models; each carries a one-year warranty.
Scan to add a JC POWER engineer
Weekdays 8:30–18:00 · 0757-81270279